Elditest CP6000 Série Manuel D'utilisation page 9

EN 61010-2-032:1995 – Particular requirements for hand-held current clamps for
electrical measurement and test equipment.
POLLUTION DEGREE DESCRIPTION
A measure of the contaminants that could occur in the environment around and
within a product. Typically the internal environment inside a product is considered
to be the same as the external. Products should be used only in the environment
for which they are rated.
Pollution Degree 1. No pollution or only dry, nonconductive pollution occurs.
Products in this category are generally encapsulated, hermetically sealed, or
located in clean rooms.
Pollution Degree 2. Normally only dry, nonconductive pollution occurs.
Occasionally a temporary conductivity that is caused by condensation must be
expected. This location is a typical office/home environment. Temporary
condensation occurs only when the product is out of service.
Pollution Degree Pollution Degree 2 (as defined in IEC 61010-1). Note: Rated
for indoor use only.
INSTALLATION (OVERVOLTAGE)
CATEGORY DESCRIPTIONS
Terminals on this product may have different installation (overvoltage) category
designations. The installation categories are:
Measurement Category I. For measurements performed on circuits not directly
connected to MAINS.
Measurement Category II. For measurements performed on circuits directly
connected to the low-voltage installation.
Measurement Category III. For measurements performed in the building
installation.
Overvoltage Category. Overvoltage Category II (as defined in IEC 61010-1)
CP6000MAN v01
7