FS IPC101-5M-WB Guide De Démarrage Rapide page 4

Name
Power Interface
Ethernet Interface
Micro SD Card Slot
Reset Button
Precautions
Test the smoothness of video playback before installing the camera to the desired
installation location, as thick or insulated walls can greatly weaken Wi-Fi signals
even if the router is nearby.
Use only approved power adapters to avoid device damage.
Avoid using the tail cable to support the camera's weight, as this may loosen the
connector.
Handle the camera carefully during transport and installation to prevent friction,
scratch or contamination.
Never point the lens directly at strong light sources like the sun or incandescent
lamps to avoid permanent damage to the lens.
Do not use organic solvents (benzene, alcohol, etc.) to clean the front glass cover.
Description
Connect to the DC 12V power
Connect to an Ethernet cable
Insert a Micro SD card (purchased separately) for local storage
Press the button for at least 15 seconds to restore the factory
default settings. Perform this within 10 minutes after the device
is powered on. Otherwise, the reset will fail.
EN 3