For Your Safety; Operating Instructions; Safety Instructions - Flex MXE 900 Instructions D'utilisation

The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with differ-
ent accessories or poorly maintained, the vibra-
tion emission may differ. This may significantly
increase the exposure level over the total working
period.
An estimation of the level of exposure to vibration
should also take into account the times when the
tool is switched off or when it is running but not ac-
tually doing the job. This may significantly reduce
the exposure level over the total working period.
Maintain the power tool and the accessories and
keep your hands warm during operation to reduce
the harmful effect of vibrations.
This power tool is supplied from singlephase al-
ternating current mains only. It is double insulated
according to EN 60745, IEC 60745 and can be
connected to grounded or not grounded sockets.
This power tool is radio suppressed in compliance
with EMC Directive 2004/108/EC.

foR yoUR sAfEty

danGer!
Before initial operation of the machine,
read the documents, listed below, and only then
start to operate the machine:
▪ The present Operating Instruction;
▪ The "Safety Instructions", enclosed in the pack-
ing (indent number No 315.915/04.10)
▪ The safety rules and instructions, valid for the
working place, for protection against accidents.
This power tool is manufactured according the
engineering level and the acknowledged Safety
rules.
Despite this, during operation a risk might arise
for the life of the operator or third person, as well
as damage of the tool or any other property dam-
age.
This power tool shall be used only:
▪ for operation, in conformity with its purpose;
▪ in perfect technical condition.

oPERAtING INstRUCtIoNs

APPlICAtIoN
▪ for operation in industry and household;
▪ for mixing low-viscosity emulsions and viscous
materials, for example: paints, lacquer, adhesives,
mortar, etc.;
▪ for operating with mixing attachments and
accessories, specified in this manual or recom-
mended by the manufacturer.

sAfEty INstRUCtIoNs

▪ The access of children to the machine is pro-
hibited.
▪ In case the supply cable is damaged during
operation, any contact to the cable is forbidden.
Unplug the machine immediately!. Never operate
a power tool with damaged supply cable.
▪ Always withdraw the plug from the power sup-
ply socket before carrying out any work on the
machine.
▪ Check the machine and the mixing attachment
prior to beginning operation for presence of dam-
ages, unbalanced attachment and vibrations.
Perform a test trial.
▪ Draw the cable behind the machine and keep it
away from the rotating parts.
while operating the machine!
▪ During operation always hold the machine with
both hands and keep proper balance.
▪ Keep the power tool away from your body.
▪ Switch off the power tool and let it stop before
you leave it aside.
▪ Keep your hands away from rotating parts of
the machine
▪ Power tools, operated outdoors or in premises
with high humidity, shall be supplied through re-
sidual current device (actuating current - max.
30 mA).
The power supply voltage shall correspond to the
value, indicated on the name plate with technical
data of the tool.
danGer!
Wear ear defenders and goggles
ProPerty damaGes
en
9