Requirements For Use; Transportation Requirements - BALAY 3XP 20 Série Mode D'emploi

Requirements for use / Transportation requirements

Requirements for use

Transportation
requirements
This appliance must be connected to a 220/240 V
50 Hz mains electricity supply using an earthed
plug.
It must be protected with a 10 A slow-action fuse.
Should an extension lead be needed, this lead must
be at least 1,5 mm
25 m. long and earthed.
There is a cavity at the back of the appliance for the
mains electricity supply connection wire.
Do not allow water to enter the appliance.
Do not block the air inlets or outlets on your
appliance, especially when used for heating.
Should the mains electricity supply wire be damaged
in any way, it must only be replaced with a wire of
similar characteristics. Get in touch with the
manufacturer, after-sales service or similarly qualified
person.
Warning!
After turning your appliance off, wait at least 3
minutes before turning it back on again. The cold
circuit needs this amount of time in order to
reset.
Warning!
This apppliance is not suitable for
dehumidification at ambient temperatures of
below 18°C.
There are castors fitted on your appliance to make
moving it easier. If it is necessary to tilt your appliance
in order to move it, then the internal water tank must
be drained first. To do this, connect drainage pipe 4 to
stopcock 8 at the bottom of the appliance, fig.
Warning!
Be particularly careful when transporting this
unit. There is a water drainage pipe on the bottom
of the appliance which may break if knocked.
30
2 per terminal thick, no more than
.
3