Checking The Connections; Basic Operations; Selecting The Component; Input Selector - Sony STR-SL50 Mode D'emploi

4
Press TEST TONE again to turn off the
test tone.
Tip
You can adjust the level of all speakers at the same
time. Press MASTER VOL +/– or turn MASTER
VOLUME on the receiver.
Note
The adjusted value are shown in the display during
adjustment.

Checking the connections

After connecting all of your components to the
receiver, do the following to verify that the
connections were made correctly.
1
Press ?/1 to turn on the receiver.
2
Turn on the component that you
connected (e.g., DVD player or VCR).
3
Press the input selector button
(e.g., DVD or VIDEO) to select the
component (program source).
4
Start playing.
If you do not obtain normal sound output after
performing this procedure, see
"Troubleshooting" on page 35 and take the
appropriate measures to correct the problem.
Tip
You can also use INPUT SELECTOR on the receiver
to select the component.

Basic Operations

Selecting the component

INPUT SELECTOR

Press INPUT SELECTOR repeatedly to select
the component you want to use.
To select
VCR
DVD player
Satellite tuner
Built in tuner
After turning on the component you selected,
select the component and play the program
source.
• After selecting VCR or DVD player, turn on the
TV and set the TV's video input to match the
component you selected.
MUTING
Press MUTING to mute the sound. "MUTING"
appears on the display when the sound is
muted. To cancel muting, press it again or turn
up the volume.
The muting function is also canceled when you
turn the power off or disconnect the power
cord.
Display/light up
VIDEO
DVD
TV/SAT
TUNER
GB
17