newcook Delicious Manuel D'utilisation page 57

Follow these steps to program your recipe:
1. Select the menu pressing the button, the display will show the selected menu accompanied initial time marked by
default.
2. Select temperature pressing the 'T' button, the LED below each number will light.
3. Select the pressure pressing the 'P' button, as directed by the recipe: none, low, medium or high. When selecting
the oven or dessert menu, which operate without pressure, it is advisable to remove the weight of the valve to get best
results.
4. Select the cooking time pressing '(+)' y '(-)', that increase or decrease one minute each time you press the button.
We recommend you follow the times set in the recipe and, if the result is not to your liking, modify the time the time to
adapt the recipe to your personal taste.
Once the cooking process starts, you can modify the parameters of temperature and pressure, according to the menu,
except for the pre-programmed that can not be adjusted pop-up menus. To cancel the menu while cooking, press the
'cancel' button.
5. Confirm and start cooking pressing the 'Cook' button. The first phase of cooking is the automatic detection of food
and heating because you select what is the actual cooking time will be displayed on the screen a screenplay in motion
until it reaches the optimum temperature for cooking. When finished, the script away and begin to cook and deduct the
time. Once finished cooking, automatically keep the food hot and will display "- - - -", until you cancel this menu. The
yellow light will turn right.
If you get confused during the selection of parameters, wait a few seconds for the display stops flashing and then '0 0 0 0' to
start the selection again.
To open the lid, the first step is to ensure there is no pressure inside (otherwise
the programmable pot will not allow you to open the lid) moving the valve in
the open position where all the steam within your programmable pot will be
ejected.
57