Climate Rating; Setting Up; Electrical Connection; Door Opening Mechanism (Touchopen) - V-ZUG WineCooler V6000 Mode D'emploi

Climate rating

Depending on the climate rating, the ap-
pliance is designed to operate in restricted
ambient temperatures. The climate rating
of your appliance is printed on the iden-
tification plate.
Keep to the specified ambient tempera-
tures in order to guarantee that the appli-
ance works properly.
Climate rating Room temperature
SN +10°C to +32°C
N +16°C to +32°C
ST +16°C to +38°C
T +16°C to +43°C
SN-ST +10°C to +38°C
SN-T +10°C to +43°C

Setting up

• Avoid positioning the appliance in direct sunlight or near cookers,
radiators and similar sources of heat.
• Standard EN 378 specifies that the room in which you install
your appliance must have a volume of 1 m
refrigerant used in the appliance, so as to avoid the formation of
inflammable gas/air mixtures in the room where the appliance is
located in the event of a leak in the refrigerant circuit. The quantity
of refrigerant used in your appliance is indicated on the type plate
on the inside of the appliance.

Electrical connection

Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type
plate. The position of the type plate is shown in the section entitled
Description of the appliance.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appli-
ance and must be easily accessible.
Do not connect the appliance using an exten-
sion cable or extension socket.
Do not use stand-alone inverters (conversion
of direct current to alternating/three-phase
current) or energy-saving plugs. Risk of dam-
age to the electronic control system!

Door opening mechanism (TouchOpen)

The appliance is equipped with a
door opening mechanism.
Opening the door
Push the door slightly inwards on
the top left-hand side and release
again.
The door is opened approx.
7 cm by the push rod.
The door can then be fully
opened.
Note
per 8 g of R 600a
3 The door will close again
automatically after approx.
3 seconds if it has not been
fully opened.
Important notes
Do not operate the appliance near magnetic fields or
place magnetic objects near the appliance.
The door may otherwise open when you do not want
it to.
Do not block the door or hold on to it while it is
opening.
If the door is blocked or held open during opening, the internal
safety coupling will be activated.
Loud, repeated cracking noises will be heard.
Do not push the push rod in or hold on to it during
closing.
If the push rod is blocked during
closing, it will no longer be able to
reach its initial position.
In the initial position, the push rod is
flush with the front of the appliance.
Setting the push rod back in its initial position
Disconnect the appliance from the mains, wait for approx.
5 seconds and plug it back in again.
The push rod returns to its initial position.
EN
EN-05