Suzuki 990D0-14J00-ALM Instructions De Montage page 2

Ref. Description
Contents
Ref. Description
Tools
Before
installation
Read this manual carefully. To emphasize special information, the following
Caution
symbol and words have been used. Pay special attention the relative notes.
Installation of this SUZUKI ORIGINAL ACCESSORY must be performed only by an authorized
SUZUKI dealer who has the proper tools and experience to do the job correctly.
a) Park the motorcycle safely on a flat level surface.
b) Keep the ignition key removed.
c) Be sure not to damage any vehicle part.
d) Check that all the parts are contained in the kit as listed in "Contents" section.
e) Disconnect the battery negative pole.
2
1 Plug & play harness
2 Sticky wired led 35cm
3 7,5A fuse
4 Fixing bi-adhesive tape 70x55x3mm
5 Tie rap 141mm
6 Installation instructions
1 Ratchet
2 Allen socket 5mm
3 Screw driver PH3 and PH2
4 Suzuki service manual
1. Park the motorbike safely on a level surface.
2. Keep the ignition key removed.
3. Be sure not to damage any vehicle part.
Check that all the parts are contained in the kit as shown in "Contents"
4.
section.
WARNING
Caution
Note
Caution – Preparation before Installation
SUZUKI GENUINE ACCESSORIES
Indicates a potentially hazardous situation which could result
in death or injury.
Indicates a potentially hazardous situation which could result
in vehicle damage.
Indicates special information to make maintenance/fitting
easier.
Caution
Q.ty
1
1
1
1
5
1
(1)
(4)
(2)
(3)