Maintenance; Troubleshooting - Haussmann SLM46G12 Manuel De L'utilisateur

MAINTENANCE

Warning – Always wear protective gloves during maintenance operations.
Do not carry out maintenance when the engine is running or hot.
Warning –Use only original manufacture's replacement parts, accessories
and attachments. Failure to do so can cause possible injury, poor
performance.
Before performing any maintenance or cleaning work, always pull out the
power cord plug!
1. Do not spray the unit with water. Contact with water may damage the
Switch/plug combination unit and the electric motor.
2. Clean the unit with a cloth, hand brush, etc.
Inspection is required:
a) If the lawn mower strikes an object.
b) If the motor stops suddenly
c) If the blade is bent (do not align!)
d) If the motor shaft is bent (do not align!)
e) If a short-circuit occurs when the lawn mower is plugged in.
f) If the gears are damaged.
Resharpen the mowing blade at the end of the mowing season or if required,
replace it with a new one.
Always have the mowing blade resharpened or replaced at an authorized
service centre to ensure proper blade balance is maintained.
Unbalanced blades will cause the lawn mower to vibrate violently.
Storing the unit
After mowing, clean the unit thoroughly. Store it in a dry room, allowing for the
motor to cool down beforehand. To reduce storage space, the upper handle can
be folded down.
Caution: Do not trap or pinch the electric cable when folding down the handle.

TROUBLESHOOTING

Before performing any maintenance or cleaning work, always pull out the
mains plug and wait until the blade has come to a standstill.
1) Motor does not run:
--- Check mains connection cable and circuit-beaker (fuse 14)
--- Start on short grass or on an area which has already been mown
--- Clean discharge channel/housing (the mowing blade must rotate freely)
--- Correct the cutting height.
25