LENCO SCD-685BK Mode D'emploi page 14

CD/USB/SD OPERATION
Loading and Playing CD Disc
Open the CD door. Install a disc with the CD graphic side facing up. Close the CD door. Press the SOURCE button to CD
mode. After reading the total number of tracks will be shown on the display. Press the PLAY/PAUSE button to play.
Reading and Playing USB Device
Insert a USB device into the USB input jack. Press the SOURCE button to USB mode. After reading the total number of
tracks will be shown on the display. Press the PLAY/PAUSE button to play.
Reading and Playing SD Card
Insert a SD card device into the SD card input jack. Press the SOURCE button to SD Card mode. After reading the total
number of tracks will be shown on the display. Press the PLAY/PAUSE button to play.
Play/Pause Control
To pause playback press the PLAY/PAUSE button. Press the button again to resume playback.
Stop Control
To stop playback press the STOP button.
Skip Track
During playback press the PREVIOUS or NEXT button to search to the previous or next track.
Random Play
During playback press the RANDOM button to play music in random order. The display will show "Random". Press the
RANDOM button again to resume normal playback.
High-Speed Music Search
During playback press & hold the BACKWARD or FORWARD button to start high-speed searching. When you
release the BACKWARD or FORWARD button normal speed playback will resume.
Repeat Playing
During playback press the REPEAT button once the display shows "Rpt.1". The current track will be played repeatedly.
Press the REPEAT button again the display shows "Rpt.all". All tracks will be played repeatedly. Press the REPEAT button
again to resume normal playback.
In case of MP3 file folder playback, there is a repeat folder as well and the display will show "Rpt.folder".
Folder Up (MP3 file only)
During MP3 playback press the FOLDER + button on the remote control (or press and hold the FOLDER+ button on the
unit) to search to the next folder (folder up).
In stop mode press the FOLDER + button on the remote control (or press and hold the FOLDER+ button on the unit) to
change the folder. Then press the PREVIOUS or NEXT
button to select your desired track to play. Press the
PLAY/PAUSE button to start playback the track.
Programmed Playback
This unit can be programmed to play any sequence of up to 20 tracks.
1. In stop mode press the PROGRAM button on the remote control. "P01" will be shown on the display.
2. Press the PREVIOUS or NEXT
button to select the desired track.
3. Press the PROGRAM button to save the desired track.
4. Repeat steps 2-4 to program up to 20 tracks.
5. Press the PLAY/PAUSE button to play according to the programmed track.
6. To clear program play press the STOP button twice or change to another mode.
7. During program play you can also do the repeat one or repeat all operation. But during program play, random play is
not supported.
14