Pair The Remote Control With The Power Unit - Husqvarna PP490 Manuel D'utilisation

Pair the remote control with the
power unit
For radio communication between the remote control and
the power unit to work, the relevant remote control must
be paired with the relevant power unit.
This is a safety measure to guarantee that the power unit
can only be controlled by one remote control. Radio
communication does not work until this measure has
been carried out.
If the accompanying remote control is exchanged or if it is
necessary to swap remote controls between two units, the
remote control must be rematched with the unit.
• Connect the remote control using the supplied CAN-
cable. Tighten the cable connector screws by hand.
• Allow the remote control to fully charge and await the
home screen. Press the "OK" button to access the
menu.
• Go to "SETTINGS". Browse with the arrow keys and
confirm with "OK".
>MENU
DRIVE CHOICES
SETTINGS
SERVICE
ASSEMBLING AND ADJUSTMENTS
OK
ON/OFF
0
20 DEC 20:55
• Go to "PAIR RADIO". Browse with the arrow keys and
confirm with "OK".
>>SETTINGS
TIME & DATE
[20:51 2010-01-12]
LANGUAGE
[ENGLISH]
SET UNITS
[METRIC]
PAIR RADIO
A message is displayed on the screen to indicate if the
pairing was successful or not.
Other software settings
A number of further settings should be made before the
power unit is commissioned. See instructions in the
"Menu system" section for additional information.
• Set time and date. (SETTINGS>TIME & DATE)
• Select the required display language.
(SETTINGS>LANGUAGE)
• Select the required units. (SETTINGS>SET UNITS)
20 DEC 20:55
English
–
9