Connect A Power Source; Battery; Insert / Remove Battery - Husqvarna PP490 Manuel D'utilisation

Connect a power source

• Connect the incoming power cable (380-480 V, 32 A).
Power packs equipped with a single phase socket
(230 V) must also have a neutral wire in order for the
socket to work. The power pack functions even if there
is no neutral wire present.
To be able to use full power output, the power unit
must be connected to a 32 A fuse. With a 16 A or 25
A fuse the power output is lower so as not to overload
the fuse. This is selected in the menu under drive
selection.
>>>SET FUSE
16A
25A
32A
At lower voltage there is a linear reduction in available
output down to 80%.
For more information, see the "Technical data" section.
• During operation, fit together the covers for the cable
and the power unit to avoid dirt entering the covers
which could damage the connector.
A gasoline or diesel driven generator can be used as a
power source if sufficiently powerful. See typical
generator operation cases in Technical Data. The
generator must be grounded to safeguard the function of
the power unit.
NOTICE! A generator which on some occasion
generates an input voltage outside the voltage range
specified in the technical data can damage the power
unit.
8 – English
ASSEMBLING AND ADJUSTMENTS
20 DEC 20:55

Battery

The remote control battery is a Li-ion type. Operating time
is about 8-10 hours per charge. Extreme cold impairs the
battery's capacity and operating time. Operating time is
also affected by the extent to which the display has been
active.
Use only original batteries for this product. Contact your
dealer for more information.
An exhausted battery must not be disposed of as
household garbage! Leave it at your nearest service
agent or collection point.

Insert / remove battery

• Insert / remove the battery.
Charge the battery.
Before using the remote control for the first time the
battery has to be charged.
To charge with the battery charger
Charging time for a flat battery is approx. 2-3 hours. The
diode is orange when charging starts and becomes green
when the battery is fully charged. When the battery is fully
charged the charger supplies the battery with
maintenance current until the battery is removed from the
charger.
Keep the battery charger dry and protected against
temperature fluctuations.
To charge with the CAN cable
The charging efficiency with the CAN cable is less than
with the battery charger and it therefore takes a bit longer
to charge the battery.
If the battery is removed while the remote control is
connected to the CAN cable, the battery symbol in the
remote control will be stricken through to indicate that
there is not battery available.