Changing The Domestic Hot Water Temperature; Temporary Switch-Off - Riello Mini 11 Manuel D'utilisation

Turn the main dial (A) to the "
Open a domestic hot water tap.
The boiler starts up, turning on the burner
after a few seconds, needed to check the
appliance. The green light (C
and stays on. When the water tap is shut-off,
the boiler switches off and prepares for the
next start-up.
If there is an anomaly when the burner
starts up, or if the safety thermostat is
tripped, the boiler performs a "LOCKOUT"
and the red light (D) comes on to signal the
"burner block".
To restore the start-up conditions, turn the main
dial (A) to " " and then to "
switches off)
time, repeat the operation 2 or 3 times. If the
problem persists, please contact the Technical
Support Service.
If there is a power cut during normal op-
eration, the boiler performs a "LOCKOUT"
(the green light (C) switches off). When
power is restored, the boiler restarts auto-
matically.
" position
" (the red light (D)
13
Changing the domestic hot
water temperature
Turn the temperature control (B) clockwise to
increase the temperature of the domestic hot
water and anti-clockwise to decrease the tem-
perature of the domestic hot water.

Temporary switch-off

In case of temporary absences for weekends,
short trips, etc.:
Turn the main dial (A) on the control panel to
the " " position
Turn the system's main switch to "OFF" and
check that the green light signal (C) switch-
es off.
ENGLISH