Recycling - ECOFOREST ecoGEO Série Manuel D'utilisateur

I
▪
f liquids or fluids are detected in the technical room, contact the technical service to check your
DANGER!
installation.
I
▪
f there is a leak in the brine circuit, the circuit should only be filled with the appropriate antifreeze
mixture; otherwise the heat pump may malfunction or even break down.
A
▪
ll maintenance work must be performed by an authorized technician. Improper handling of the
equipment as a whole can result in personal injury and/or damage to materials.
D
▪
o not spill water or other liquids directly on the heat pump to clean it, as this could cause an electric
shock or fire.
C
▪
leaning and user maintenance shall not be made by children without supervision.
T
▪
he filling and refilling water must comply with local regulations and the indications shown in the
heat pump installation manual.
The pressure of the brine and production circuits should be checked regularly. The proper circuit pressure values can be found in the
information menu. Circuit pressures should be between 0.7 and 2 bar. If the pressure drops below the minimum setting established
by your technical service, the heat pump will shut down automatically, the corresponding alarm will go off and equipment status will
switch to EMERGENCY.
Use a moist cloth to clean the outside of the heat pump. Do not use abrasive cleaning products that may damage the paint.

1.3. Recycling

▪
The heat pump cannot be disposed of with household waste.
▪
When its useful life ends, carry out the elimination of the appliance in accordance with the local
regulations in force, in a correct and respectful way with the environment.
The heat pump contains refrigerant inside. The refrigerants used by Ecoforest are not harmful to the environment, but once its useful
life cycle has finished, the refrigerant must be recovered to be recycled or disposed of according to current regulations.
29
User manual