Dhw/Legionella Prot. Menu - ECOFOREST ecoGEO Série Manuel D'utilisateur

4/8 ooling
Enable:
StopT:
Active:
Passive:
ooling buffer
SetT:
DTstart:

ooling groups
-  +
DG: SG:
3
SG3: SG4:
oom terminals
SetT

DG: 
SG: 
SG3: 
SG4: 

3.13. DHW/LEGIONELLA PROT. Menu

User menu 5/8
efrigeracin
DHW/Legionella prot
Pool
5/8 DHW
Enable:
emote control: ON
SetT
DTstart:
SetT HT:
DHW recirculation
Enable:
SetT
DTstart:
: 4: ON
: : ON
3: : ON
4: 4: OFF
Legionella
Enable:
Start time:
5
Mon: Tue:
Wed: Thu:
Fri: Sat:
Sun:
Cooling
This is used to enable the COOLING mode and adjust the active and passive cooling cut-off
8 temperatures. The COOLING mode cannot be activated for outside temperatures under the

cooling cut-off temperature. Only PASSIVE COOLING can be activated for outside
temperatures between passive and active cut-off temperatures. ACTIVE COOLING
activation is only allowed for outside temperatures over the active cooling cut-off
temperature.
The icon indicates that there is a time schedule activated in the COOLING mode.
Cooling buffer
This shows the setpoint temperature of the cooling buffer storage tank and allows
8
3 adjustments to be made to the start-up temperature differential.
Cooling groups
-  +
This can be used to adjust the cooling target outlet temperatures programmed by the
technical service. Each ramp increases or decreased the outlet temperature by 2ºC.
Room terminals
DTc

Used to show and adjust the inside environment temperature setpoint (SetT) and the

 comfort temperature differential (DTc) of the terminals of each outlet unit.


DHW
This is used to enable the DHW mode and adjust the setpoint temperature and start-up
48 temperature differential for the DHW storage tank. In ecoGEO range It is also used to adjust
5
the setpoint temperature for DHW heating with the HTR system.
7
The icon indicates that there is a time schedule activated in the DHW mode.
DHW Recirculation
45
This is used to set up as many as 4 time periods per day for DHW recirculation.
5
In ecoAIR and ecoGEO HP range, it can also be used to adjust the start-up setpoint
temperature and the start-up temperature differential for DHW recirculation.
Legionella protection program
3:
This is used to set up a weekly program for protection against legionella.
The legionella protection program is deactivated automatically if 5 hours have elapsed
without reaching the final temperature set up by the technical service.
Legionella protection programs should be carried out at night, or when there is no DHW
consumption.
43
User manual