Information Display; Troubleshooting - Teac Pd-507T Mode D'emploi

Settings (continued)

Information display

This shows the version of the firmware used by the unit .
MENU
VERSION INFO
SYSTEM
SYSTEM
The microcomputer firmware version
CD DRIVE
The CD drive firmware version
24

Troubleshooting

If you experience a problem with this product, please take a
moment to review the following information before requesting ser-
vice . If it still does not operate correctly, contact the retailer where
you purchased the unit .
General
The unit does not turn on.
e Check that the power cord is completely plugged into the
power outlet . If the outlet is switched, confirm that the switch
is in the ON position .
e Connect a different electrical device to the outlet to confirm
that it is supplying power .
e If the automatic power saving function has caused the unit to
enter standby, press the remote control STANDBY/ON button
to turn the unit on again .
The unit automatically enters standby mode.
e This is because the automatic power saving function put the
unit into standby . Set the STANDBY/ON switch to STANDBY
once and then set it to ON again .
Change the automatic power saving setting if necessary
(page 22) .
Remote control does not work.
e Turn the main unit on (page 16) .
e If the batteries are exhausted, replace both of them with new
ones (page 12) .
e The remote control will not work if there are obstructions
between it and the main unit . Point the remote control at the
front panel of the unit from a distance of less than about 5 m
(16 ft) (page 12) .
A television or other device is operating improperly.
e The use of this unit's remote control might cause some televi-
sions and other devices with wireless remote control functions
to operate incorrectly .
There is a humming noise.
e If a connecting cable is near a power cord, fluorescent light or
similar cause of interference, increase the distance between
them as much as possible .
No sound is output.
e If a stereo amplifier is connected to this unit, adjust its volume .
e Reconfirm the connections with other equipment .
e Set the digital output (DIGITAL OUT) according to the digital
audio output connector (COAXIAL or OPTICAL) being con-
nected (page 22) .