Teac PD-507T Mode D'emploi page 19

3 Continue to input the numbers for the tracks
you want to program.
4
Press the play/pause (7/9) button to start
program playback.
o Skipping, searching and repeat playback functions can be used
during program playback .
NOTE
When "PGM" appears at the top right of the display, what happens
when number buttons are used to input track numbers depends on
the PROGRAM PLAY setting (page 23) .
Checking the program order
Press the skip (.//) buttons when playback is stopped to
change the program step shown, allowing the program order to be
checked .
Press the stop (8) button when finished checking .
Changing programmed tracks
Pressing the skip (.//) buttons when playback is stopped
causes the program step to blink, showing the program editing
mode is active .
Press the stop (8) button to end program editing mode .
Inserting tracks
1 Use the skip (.//) buttons when play-
back is stopped to show the program step
where you want to insert a track.
Display example
TRACK 8
8
P02
Program step blinks
2
Use the number buttons to input track numbers.
Display example
TRACK 8
6
P03
o In this example, track number 6 has been added at program
step 3 . The tracks on all the following program steps will be
pushed to later steps .
o Continue inputting track numbers to insert multiple tracks .
3 Press the stop (8) button to end editing.
EN
PGM
6:31
PGM
10:41
19