Intended Use - VOLTCRAFT 51 13 60 Notice D'emploi

Intended Use

The connection and operation of consumers with an operating voltage of either
115 V~, 125V~, 230V~ or 240 V~ to the appropriate sockets.
Depending on the input voltage, 115 V~, 125V~, 230V~ or 240 VAC, the pre-settable
output voltages are available on the earthing-pin socket (1).
Only 115V~ is pending at the US socket independent of the input voltage. This volt-
age cannot be altered.
The power consumption of a connected consumer may not exceed 400 VA for type
AT-400, 1000VA for type AT-1000 or a of max. 1500 VA for type AT-1500. If this is
exceeded or a short takes place, it can lead to overloading and thus to destruction of
the series transformer.
An auto-transformer supplies the desired voltages. The outputs are electrically con-
nected with the input mains voltage.
The devices are constructed in accordance with protection class 1. They are only
licensed for connection to sockets with earthing and, depending on the adjustment
of the voltage selection switch at the input, with an alternating voltage of
115V/125V/230V and 240V~ /50-60Hz.
The in and outputs are secured by fuses.
Use in damp rooms or outdoors or under adverse ambient conditions is not permit-
ted. The following are unfavourable ambient conditions:
- wetness or excessive humidity
- dust or combustible gases, vapours or solvents
- strong vibration
Use other than that described above will damage the product and may involve other
risks such as short circuit, fire and electric shock etc. Do not change or modify any
part of the product. The safety instructions have to be observed at all times!
13