Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Troubleshooting
13.2 Anti-scalding protection / temperature limit
WARNING Burns
When operating with preheated water, the set anti-scald-
ing protection may be ineffective.
f In this case, restrict the temperature at the upstream
f
central thermostatic valve (see chapter "Installation /
Appliance description / Accessories").
DCE 11/13 | DCE 11/13 H
The anti-scalding protection "max. 43 °C" is activated by reposi-
tioning the plug on the circuit board in the appliance cap.
60 °C
1
1 Without anti-scalding protection
2 With anti-scalding protection 43 °C
f Remove the electronic PCB from the programming unit of the
f
appliance cover. Be careful with the snap-on hooks.
f Move the plug to the "43 °C" position.
f
f Refit the electronic PCB, ensuring the snap-on hooks click
f
into place. Observe the positions of the push-button and
shaft.
DCE 11/13 RC
The anti-scalding protection "max. 43 °C" is activated by changing
the setting of the DIP switch in the appliance.
1
4
1 DIP switch for anti-scalding protection
2 Without anti-scalding protection = 60 °C
3 With anti-scalding protection = max. 43 °C
4 Green LED indicator: Permanently illuminated when an-
ti-scalding protection is active
28
|DCE 11/13| DCE 11/13 RC| DCE 11/13 H
13.3 Conversion for power connection from below
1 Power cable
2 Cable grommet
3 Strain relief
4 Mains terminal
5 Marker for power cable aperture
6 Plug
43 °C
7 Wire guides
f Remove the strain relief fitting and the power cable with the
f
cable grommet.
f Seal the top opening in the back panel using the enclosed
f
2
(sealed) plug. Protection rating IP 25 (hoseproof) can only be
guaranteed with a correctly fitted plug.
f Reposition the mains terminal in the appliance from the top
f
to the bottom. Ensure that the mains terminal clicks into
place.
f Route the control wires under the wire guide.
f
f Provide an aperture for the power cable at the back of the
f
appliance. For this, use a suitable tool to apply pressure
along the circular plastic knock-out marking on the appliance
back panel, pushing from the inside out. If necessary, use a
file.
!
2
f Fit the power cable with the cable grommet to the appliance
f
60°C
back panel.
f Connect the power cable to the mains terminal (see chapter
f
"Installation / Specification / Wiring diagram").
f Fit the strain relief.
f
43°C
14. Troubleshooting
3
1
2
3
4
5
Material losses
f If the appliance back panel is damaged, replace it.
f
WARNING Electrocution
In order to test the appliance it must be connected to the
power supply.
www.stiebel-eltron.com
6
7
3
2
1
4
Publicité
Chapitres
Table des Matières
Dépannage
