How To Use - Panasonic E Série Instructions D'utilisation

How to use

To select operation mode
AUTO - For your convenience
• During initial operation mode selection, the
Power indicator blinks.
• Unit selects operation mode every
Single
10 minutes according to setting
temperature and room temperature.
• Unit selects operation mode
Multi
every 3 hours according to setting
temperature, outdoor temperature and
room temperature.
HEAT - To enjoy warm air
• Unit may take a while to warm up. The POWER
indicator blinks during the initial warm up
operation.
COOL - To enjoy cool air
• Provides effi cient comfort cooling to suit your
needs.
DRY - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
FAN - To circulate air in the room
To reach temperature quickly
POWERFUL
POWERFUL
• This operation stops automatically after
Single
20 minutes.
• Press the button again or turn OFF the
Multi
unit to stop this operation.
OFF/ON button
Use when remote control is misplaced or a malfunction occurs.
1. Press the button once to use in AUTO mode.
2. Press and hold the button until you hear 1 beep, then release to use in forced COOL
mode.
3. Repeat step 2. Press and hold the button until you hear 2 beeps, then release to use in
normal COOL mode.
4. Repeat step 3. Press and hold the button until you hear 3 beeps, then release to use in
forced HEAT mode.
• Press the button again to turn off.
6
Remote control receiver
POWER
TIMER
POWERFUL
QUIET
Remote control display
AIR CONDITIONER AIR CONDITIONER
MODE MODE
POWERFUL QUIET
Single split system
Single
Multi split system
Multi
Indicator
(Green)
(Orange)
(Orange)
(Orange)
Press and hold for
approximately
10 seconds to show
temperature setting in
°F or °C.
Press and hold for
approximately
5 seconds to show
12-hour (am/pm) or
24-hour time indication.
Press to restore the
remote control to
default setting.
Not used in normal
operations.