Hatco HBG Série Manuel D'installation Et D'utilisation page 12

OPTIONS AND ACCESSORIES
102 mm Adjustable Legs (HBG Model)
NOTE: 102 mm (4") legs are included with models greater than
1041 mm (36") in width.
WARNING
ELECTRIC SHOCk HAZARD: Turn OFF power switch,
unplug power cord, and allow unit to cool before
performing any cleaning, setup, or maintenance.
NOTICE
Do not lay unit on the side with the control panel or
damage to unit could occur.
NOTE: The feet on the 4" legs are adjustable for leveling the
unit. Use a 5/8" (16 mm) open-end wrench to make
leveling adjustments once the unit is placed in its final
position.
149 mm
(5-7/8")
174 mm
(6-7/8")
98 mm
(3-7/8")
Front View of Cutout
4" Leg
IMPORTANT NOTE:
162 mm
(6-3/8")
Remote Mounted Control Panel (HBGB)
WARNING
ELECTRIC SHOCk HAZARD: Remote mounted control
panel must be mounted on a vertical wall and installed in
vertical position. Mounting control panel in horizontal
position may result in collection of liquids and lead to an
electric shock.
NOTICE
The remote mounted control panel should be installed
outside of the heat zone. Locating the control panel inside
the heat zone will cause the control(s) to overheat,
malfunction, and fail.
Do not modify wiring or cut thermostat capillary wire on
control box to increase semi-remote mounting distance.
Cutting the thermostat capillary wire will cause the unit to
overheat and may damage the unit as well as the
surrounding countertop.
NOTE: A qualified electrician is recommended for installing the
remote mounted control panel.
NOTE: Units are equipped with a 914 mm ( ),
flexible conduit connecting the control
panel to the unit.
Indicating Temperature Control (ITC)
Thermostat Enclosure
Trim Cover
Side View of Installed Enclosure
121 mm (4-3/4")
102 mm (4")
Control Enclosure
Mounting Surface