Figure 85. Installing the eDP cable
Étapes
1. Connect the eDP cable to the connector (LCD1) on the camera module.
2. Adhere the eDP cable to the display back cover.
3. Adhere the conductive tape and route the eDP cable to the display back cover.
Étapes suivantes
1. Install the camera.
2. Install the
display-panel
3. Install the
display
bezel.
4. Install the
display
assembly.
5. Install the
base
cover.
6. Follow the procedure in
Assemblage du capot arrière de l'écran
Removing the display back-cover assembly
PRÉCAUTION :
The information in this removal section is intended for authorized service technicians only.
Prérequis
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
display
assembly.
assembly.
After working inside your
computer.
Before working inside your
computer.
Retrait et installation des unités remplaçables sur site (FRU)
113