Cleaning And Maintenance - Mpm Mod-25 Manuel De L'utilisateur

5. Clean the air filters at least every month (depending on the usage). If a filter is too dirty or damaged,
replace it with a new one.
6. When reinstalling the filters ⑭ and ⑮ in the cyclone chamber ⑨, the motor sponge filter ⑭ must
be inside the motor HEPA filter ⑮ casing, toward the grill. The motor HEPA filter ⑮ casing must
face up with the tab so that the latter presses the alignment lock. The motor HEPA filter ⑮ casing
is press fitted inside the cyclone chamber ⑨ and has no latches.
7. Install the air discharge HEPA filter ⑯ in the back of the vacuum cleaner canister. Check that its
latch is properly engaged. Next, replace the grill ⑰.
CAUTION! The filter must be completely dry before installation. Installation of a wet filter may
cause an electric shock.

CLEANING AND MAINTENANCE

1. Periodically wipe clean the vacuum cleaner canister, the cyclone chamber and the dust canister
with a damp cloth. This will keep a neat appearance for a long time.
2. Do not clean with sharp objects or strong detergents (e.g. solvents), as they will cause permanent
damage to the vacuum cleaner canister.
3. Maintain the air filters as explained above.
TROUBLESHOOTING
Problem:
The cyclone chamber with the dust canister
cannot be placed in their seat.
Vacuum cleaner canister overheating.
Low suction power.
Possible causes:
The motor filters were not properly
installed.
A slight increase in the temperature of the vacuum cleaner canister is normal. If the
temperature is rising considerably, immediately turn off the vacuum cleaner and wait until
cools.
The air filters are very dirty.
The dust canister is full.
The suction hose and/or the telescopic wand
is clogged.
Solution:
Install the motor filters properly.
Clean or replace the filters.
Empty the dust canister.
Unclog the suction hose and/or the
telescopic wand.
EN
23