MPM MOD-25 Manuel De L'utilisateur page 22

EN
SMALL MULTIFUNCTIONAL BRUSH WITH ADAPTER
Intended for cleaning flat surfaces, furniture, upholstery, and mattresses. The compact
sizes make it perfect for cleaning hard to reach places and whenever the floor and carpet
tool is too big. Install the brush on the adapter to easily clean blinds, furniture, soft sur-
faces (e.g. upholstered seats), upholstered chairs, creases and pleats on puffs, sofas, or
couches, and fragile objects, e.g. lampshades.
PARQUET BRUSH TOOL
Intended for cleaning all surfaces prone to scratching, e.g. wooden floors, varnished par-
quet floors, or flooring panels.
SMALL TURBO BRUSH
Designed for efficient cleaning of surfaces such as carpets, car pet flooring.
SLIDE-OUT CREVICE TOOL
Used for cleaning difficult to access areas, such as in room corners, by and below pieces
of furniture and in bends and slits. It is also perfect for cleaning computer keyboards,
drawers, radiators or window frames.
EMPTYING THE DUST CANISTER
Emptying the dust canister ⑨: Unplug the vacuum cleaner from the mains and disconnect
the suction hose ⑲. Press and hold the cyclone chamber & dust canister release latch ④
with one hand, and lift the dust canister clear from the vacuum cleaner by its handle ⑩
with the other hand. Keeping the dust canister over a dust bin, open the lid ⑫ with
the latch ⑪. When emptying the dust canister, check that the cyclone chamber and the
cone prefilter ⑬ are clean. You can remove the cone prefilter by turning it slightly coun-
ter-clockwise and pulling it clear from the cyclone chamber. Do the same in the reverse
order to install the cone prefilter.
With the dust container empty and the cyclone chamber clean, close the lid ⑫ and re-
install the dust container with the cyclone chamber ⑨ in the cyclone chamber & dust
canister seat ⑤.
AIR FILTER CLEANING AND REPLACEMENT
Normal use of the vacuum cleaner requires periodical replacement or cleaning of the air
filters which protect the motor on the cyclone chamber end, and the air discharge filter.
Unplug the vacuum cleaner from the mains and disconnect the suction hose before clean-
ing the vacuum cleaner.
1. Remove the cyclone chamber ⑨ from the vacuum cleaner. Remove the motor HEPA filter ⑮ with
the motor sponge filter ⑭. Separate the filters from each other.
2. Press both release latches ⑧ to remove the grille ⑰. Remove the air discharge HEPA filter ⑯ by
pressing the release latch at the HEPA filter top.
3. Clean the HEPA filters ⑮ and ⑯ with a soft brush or by blowing with a low-pressure stream of air.
Do not wash the HEPA filters with water or other liquids.
4. First, clean the motor sponge filter ⑭ from all dust and debris by shaking. Next, wash it in luke-
warm water and leave to dry completely. The motor sponge filter must be perfectly dry before
reinstallation.
22