Care And Storage - DS Produkte 03996 Mode D'emploi

Spiral and Volume Brush
There are two extra attachments for the curling iron (1): The spiral (4) for tight, sharp
curls and the volume brush (5) for soft curls.

Care and Storage

PLEASE NOTE!
■ Before commencing the cleaning, note the safety instructions in the "Safety
Instructions" chapter!
■ Never rinse the device with water and never immerse it in water or other liquids. Nev-
er clean the device with a steamer.
■ Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the de-
vice. These could damage the surfaces.
We recommend cleaning the attachments after each use so that no hairs or residues of
styling products etc. can accumulate on them.
1. Disconnect the device from the mains power and allow it to cool down completely
before cleaning it.
2. Remove hair and fl uff from the brushes. Wipe down the curling iron (1) and the heat-
ing plates (3 + 6) with a soft, damp cloth to remove any possible residues (e.g. of
hair-care products).
19
The spiral or the volume brush are placed on the curling iron
as far as they will go. When you do this, make sure that the
longer end of the spiral / volume brush does not rest on the
curling tongs.
To take off the spiral / volume brush, open the curling tongs
and turn the spiral / volume brush a little to release it from its
locked position.
Using the spiral: Clamp individual thin strands of hair in the
curling tongs and then wrap them around the curling iron. The
strands will be placed in the grooves of the spiral. This will
keep them narrow and curl them evenly. Hold them in position
for a few seconds, then carefully unwind.
Using the volume brush: Wind individual strands of hair
around the brush, hold them in position for a few seconds and
then gently unwind.
EN