Using Attachments - DS Produkte 03996 Mode D'emploi

4. Meanwhile thoroughly comb through the hair. There must not be any knots in the hair.
We recommend using a heat protection spray to protect the hair.
5. Once the attachment has heated up, you can start using it: Partition off the top hair
and start with the bottom strands of hair. Shape each strand individually with the at-
tachment until the result is satisfactory. Do not hold the hot attachment in one spot for
too long! This could damage the hair.
6. To switch off the device, press the On / Off button again. The operating lamp (11)
goes out.
7. Pull the mains plug out of the plug socket and allow the attachment to cool down if the
device is no longer being used or before the attachment is replaced.
8. Allow the hair to cool and only then style it with a comb or brush if necessary.

Using Attachments

Straightening Brush
Use only heat protection and do not use any other styling products such as hair spray,
gel or mousse! These can stick to the straightening brush (7).
Inserting Heating Plates
1. Open the the hair straightener and crimping tongs (8) (Press together the lever and
shaft.).
17
1. Divide the hair up into sections.
2. Move the straightening brush slowly through the sections
of hair so that each area of hair is exposed to the heat for
no more than two seconds. Do not touch the scalp!
3. Brush the respective section of hair in several goes to
achieve a good end result without damaging the hair by
dwelling on one spot for too long.
2. Hold the heating plates (3 + 6) by the plastic handle and
slide them into the rails of the tongs. Note the follow-
ing when doing this: The heating plates are of different
heights and must be plugged into the matching half of the
tongs. Do not apply any force! They must slide in easily
and be heard to engage in place. If this is not the case, try
the other half of the tongs.
3. To pull the heating plate out of the tongs, press the two
release buttons on the side of the plastic handle.
EN