Makita DSD180 Manuel D'instruction page 7

1
► 1. Lamp
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Removing the dust collector
CAUTION:
Never operate the tool without the
dust collector. Dust may come into your eyes and
cause eye injury.
To remove the dust collector, hold the tool handle and
pull back the tabs on the tool. Be sure to pull the tabs on
the both sides at the same time.
► 1. Tab
When installing, align the dust collector's edge with the
groove on the base.
► 1. Groove
Replacing drywall saw blade
CAUTION:
eign matter adhering to the blade and/or blade
holder. Failure to do so may cause insufficient tight-
ening of the blade, resulting in a serious personal
injury.
CAUTION:
workpiece immediately after operation. They may
be extremely hot and could burn your skin.
CAUTION:
erly secured. Insufficient tightening of the blade may
cause blade breakage or serious personal injury.
1. Remove the dust collector.
2. Remove the bolts on the blade holder with the hex
wrench.
1
► 1. Bolts 2. Blade holder 3. Blade
1
3. Set a new blade as shown in the figure. Make sure
that the curved edge of the blade points forward. Fit the
protrusion of the blade holder into the slot on the blade.
7 ENGLISH
1
Always clean out all chips or for-
Do not touch the blade or the
Make sure that the blade is prop-
2
3