Safety Instructions - Simu T3.5DC ESP HZ Notice Originale

5151225A

SAFETY INSTRUCTIONS

EN – ORIGINAL INSTRUCTIONS
SIMU S.A.S. au capital de 5 000 000 € - Z.I. Les Giranaux - 70100 ARC-LÈS-GRAY - FRANCE - RCS VESOUL B 425 650 090 - SIRET 425 650 090 00011 - n° T.V.A CEE FR 87 425 650 090
These safety instructions supplement the drive Instructions. To contact a SIMU representative,
go to www.simu.com. Please give these instructions to the user after installation.
I. SAFETY INSTRUCTIONS FOR DRIVE INSTALLATION. WARNING: Important safety
instructions. Follow all instructions, since incorrect installation can lead to severe injury.
Inspect all parts prior to installation. The drive Instructions enclosed with this document sets
out the fields of application of the drive, the minimum tube diameter for tubular drives, the
information necessary for mounting and securing the drive, connecting it to the power supply
and setting the controls, and the maintenance operations relating to the drive itself. Only
use SIMU accessories (wheel, ring, mount, very low voltage power supply) and controls
compatible with the drive. Ensure that the weight and dimension of the product to be
motorised are compatible with the rated torque and rated operating time. These information
are available from your SIMU contact. Before installing the drive, remove any unnecessary
cords and disable any equipment not needed for powered operation. The actuating member
of a biased-off switch is to be located within direct sight of the driven part but away from
moving parts. It is to be installed at a minimum height of 1,5 m and not accessible to the
public. Fixed controls shall be clearly visible after installation. A suitable multi-pole switching
device must be incorporated upstream in the fixed wiring in accordance with the wiring rules.
If the supply cord is damaged, it must be replaced by an identical cord. If the cord is not
removable, return the drive to after sales department to avoid a hazard. If the drive is fitted
with a manual release, install its actuating member at a height less than 1,8 m. For drive for
projecting awnings with an edge at a height <2m from the ground or any other access level,
maintain a horizontal distance of at least 0.4 m between the fully unrolled driven part and
any permanent object.
II. SAFETY INSTRUCTIONS FOR DRIVE USE AND MAINTENANCE. WARNING:
Important safety instructions. It is important for the safety of persons to follow these
instructions. Save these instructions. WARNING: The drive shall be disconnected from
its power source during cleaning, maintenance and when replacing parts. This appliance
can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision. Do not allow children to play with fixed
controls. Keep remote controls away from children. Frequently examine the installation for
imbalance and signs of wear or damage to cables and springs. Do not use if repair or
adjustment is necessary. Watch the motorised installation while it is moving and keep people
away until the motorised installation is fully extended. For drives fitted with a black H05-RRF
cable for outdoor installations, the cord must only be replaced by an identical cord supplied
by manufacturer of the drive. For drives powered by a very low voltage removable power
supply, only the power supply provided with the drive must be used. For drives fitted with
a manual release, operating conditions are given in the drive Instructions. LpA ≤70 dB(A).
EN
1/8