Simu T3.5DC ESP HZ Notice Originale page 12

2.3- End limit setting:
Semi-automatic setting for awnings with blockers for UP end limit:
> 2 s
1- Move the motor to the desired DOWN end-limit position using the UP and DOWN buttons. (If you hold
the UP or DOWN button for more than 2 seconds the awning will move automatically in the UP or DOWN
direction. You will then have to stop the awning at the desired end-limit position by pressing the STOP
button.)
2- To set the DOWN end limit position, press simultaneously the STOP and UP buttons. The motor will run
automatically in the UP direction.
3- (Optional) Press STOP button to stop the motor.
4- To confirm the end limits press for 2 seconds on STOP. The motor will run for 0.5 second in one direction,
then in the other direction. The operation is completed. Go to section 3.
Manual setting for awnings without blockers for UP end limit:
1
+
> 2 s
1- Move the motor to the desired DOWN end limit position using the DOWN and UP buttons. (If you hold the
UP or DOWN button for more than 2 seconds the awning will move automatically in the up or down direction.
You will then have to stop the awning at the wished end-limit position by pressing the STOP button.)
2- To set the DOWN end limit position, press simultaneously the STOP and UP buttons. The motor will run
automatically in the UP direction.
3- Before the motor reaches the UP end limit, press the STOP button.
4- If necessary adjust the position with the UP and DOWN buttons.
5- To set the UP end limit position, press simultaneously the STOP and DOWN buttons. The motor will run
automatically in the DOWN direction.
6- (Optional) Press STOP button to stop the motor.
7- Press the "STOP" button for 2 s. The motor will run for 0.5 second in one direction and then in the other. The
operation is completed. Go to section 3.
If you do not want to use this transmitter as the individual control:
- Switch the power supply off (2 seconds minimum (battery and solar panel)).
- Repeat the operation 2.1* with a new transmitter and then go to section 3.* In this case, the motor will run
for 0.5 second in both directions, that means the limits setting is already done.
PROGRAMMING THE FIRST INDIVIDUAL POINT OF CONTROL
3
This operation can only be performed from the transmitter that was used for operation 2.1-3.
- Press the transmitter PROG button for approximately 1
second. The motor will run for 0.5 second in one direction
and then in the other. The operation is completed.
Your transmitter is now programmed to control the
motor in stable mode.
EN
4/8
1 2
+
2 3
3
4 5
1
PROG 1 s
4
2 s
6 7
2 s
>>