Simu T3.5DC ESP HZ Notice Originale page 15

« BACK RELEASE" FUNCTION
9
This function enables the release of the fabric tension after the complete closing of the box awning.
For safety reasons, this function can only be activated or deactivated by the individual control
point in 3 situations:
• After the settings confirmation and before programming the first control point.
• After programming the first control point and during the next 4 cycles.
• After a single power outage and during the next 4 cycles.
To activate or deactivate this function, the procedure is the same:
1- Move the motor to the UP end limit previously set in section 2.3 with the UP button.
2- Press simultaneously the STOP and DOWN buttons for 5 seconds. The motor
will run for 0.5 second in one direction, then in the other direction. The operation
is completed.
The «back release» function is disable in the factory mode.
END LIMIT RE-ADJUSTMENT
10
10.1- DOWN end limit re-adjustment :
1- Move the motor to the DOWN end limit previously set in
section 2.3 with the DOWN button.
2- Press simultaneously for 5 seconds the UP and DOWN
buttons, the motor will run for 0.5 second in one direction,
then in the other direction.
3- Move to the new position with the UP and DOWN buttons.
4- Confirm the new position by pressing 2 seconds the STOP
button. The motor will run for 0,5 second in one direction
and then in the other direction. The new end limit setting is
memorized.
10.2- UP end limit re-adjustment (only in case of manual setting, awnings without blockers for UP end limit):
1- Move the motor to the UP end limit previously set in section
2.3 with the UP button.
2- Press simultaneously for 5 seconds the UP and DOWN
buttons, the motor will jog in both directions.
3- Move to the new position with the UP and DOWN buttons.
4- Confirm the new position by pressing 2 seconds the STOP
button. The motor will run for 0,5 second in one direction
and then in the other direction. The new end limits setting is
memorized.
1
1 2 3
5 s
1 2
5 s
2
5 s
4
2 s
3 4
2 s
EN
7/8