Menu Settings; Button Settings - Perel SCAMSET Mode D'emploi

3. Connect the wires to the monitor and electrical lock as shown on the wiring diagram.
4.
Attach the bracket as shown, using the included wall anchors and screws.
7. Operation
•
When a visitor presses the call button on the outdoor camera, the bell tone sounds and the display
switches on.
•
Press to speak to the visitor.
•
Press to open the door.
•
When you have finished speaking to the visitor, press
The display switches off automatically.
8. Settings on the Monitor
8.1

Menu Settings

On the menu of the monitor, you can change the following settings:
•
Brightness: sets the image brightness.
•
Contrast: sets the image contrast.
•
Saturation: sets the image saturation.
•
Audio: sets the volume on the monitor.
To adjust the volume on the intercom, use the potentiometer on the back panel of the monitor.
Using the menu
•
To switch on the monitor, press the doorbell on the outdoor camera.
•
On the monitor, press
•
Press to select the setting you want to change.
•
Press or
•
The menu disappears automatically after a few seconds.
Reset
To reset all settings:
•
On the monitor, press
•
Press to select Reset.
•
Press or
Exit
The menu disappears automatically after a few seconds.
You can also exit the menu manually, as follows:
•
Press to select Exit.
•
Press or
8.2

Button Settings

Bell tone
Mute
V. 02 – 30/10/2013
to enter the menu.
to change the setting.
to enter the menu.
to reset the device.
to exit the menu.
The monitor has several bell tones.
Press to browse through the tones and set another tone.
•
Press to mute the bell.
•
While mute is active, the
•
When someone calls at the door, the display switches on without a bell
tone.
•
Press again to cancel mute.
SCAMSET
again.
LED on the device flashes.
7 ©Velleman nv