Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Replacing/cleaning the spark arrester screen
CAUTION:
Do not use sharp or pointed objects for screen cleaning.
Damaged or misformed screen wires may result.
The spark arrester screen should be checked and cleaned
regularly.
Let cool the engine down for sure!
Unscrew and remove screw (1). Remove the spark
arrester screen (2).
Cleaning or replacing the spark arrester screen.
Reassembly the spark arrester screen and tighten the screw.
Instructions for periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be per-
formed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform the
prescribed maintenance work can lead to accidents!
Users of the Power Cut must not perform any maintenance work not described in this Operator's manual. All such work must be
carried out by a DOLMAR service center.
General
Before each start
Every day
Every week
Monthly
Every 3 months
Annually
Storage
Entire Power Cut
Cutting disc
Clutch
Protection hood
Cutting disc
Protective hood
Combination switch,
Safety locking button,
Throttle lever
Tank cap
Idle speed
Starter housing
Starter cable
V-belt
Spark plug
Muffler
Spark arrester screen
Screws and nuts
Air filter insert
Suction head
Fuel tank
Entire Power Cut
Entire Power Cut
Cutting disc
Fuel tank
Carburetor
1
2
Clean exterior, check for damage. In case of damage,
have repaired by a qualified service center immediately
Inspect regularly for damage and wear.
Have inspected at a service center.
Clean
Inspect for damage and make sure the cutting wheel is
right for the job
Adjust position
Functional check
Functional check
Functional check
Check for tightness
Check (cutting disc must not turn on idle)
Clean to ensure proper air cooling
Check for damage
Inspect for damage and wear
Check and replace if necessary
Check tightness of mounting
Clean or replace if necessary
Check their condition and that they are firmly secured.
Check the air filter insert, clean as needed,
replace after 500 operating hours
Replace
Clean
Check at an authorized service center
Clean exterior, check for damage. In case of damage,
have repaired by a qualified service center immediately
Remove and clean
Empty and clean
Run empty
Page
8
21
8
18
18
19
14
23
20
22
14
26
21
22
15
25
Publicité
Chapitres
Table des Matières
