Varan ST6-1600 Manuel D'utilisation page 16

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATING INSTRUCTIONS
Pre start-up inspection.
The following Pre-start-up inspection must be performed before the start of each work session or
after every four hours of use, whichever is first. Please refer to the service section for detailed
guidance. If any fault is discovered, the Promix must not be used until the fault is rectified.
1. Thoroughly inspect the mixer for signs of damage. Check components are present and secure.
Pay special attention to the Mixing Paddle, and ensure it is correctly attached to the handle.
2. Check electricity cables for signs of exposed wires. Fix any exposed areas before operating.
Operating Instructions
Before you operate or carry out any maintenance on this machine YOU
MUST READ and STUDY this manual.
Always operate the machine with both hands on the handle.
Press and hold the trigger (2) to commence the mixing process.
Once the trigger (2) is in the 'ON' position, push the trigger lock button (3). This will hold the trigger
(2) in the 'ON' position without the use of your hand.
To stop the machine, push and release the trigger (2).
Machines with 2-speed gearboxes have 2 speeds available. The first gear is the slow speed, and the
second gear is the fast speed. To change from one gear to the other, turn the gear change switch (1)
O
through 180
. There is also a Variable Speed Dial (7) available which allows you to vary the speed of
the machine when using either of the 2 gears.
Always reduce the speed when placing the mixing paddle into the mixing material, and also when
removing it. Once the mixing paddle (6) is completely clear of the mixing material, increase the speed
again to ensure that the motor is adequately cooled.
During the mixing process, slowly move the machine around the mixing container. This should be
continued until all of the mixing material has been mixed.
Once the mixing process has been completed, clean the mixing paddle (6) to stop the build up of dirt
and residue.
Varan motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
T: 00352/26908036 – F: 00352/26908040
ST6-1600

Publicité

Table des Matières
loading

Table des Matières