TFA 60.2553 Mode D'emploi page 10

TFA_No. 60.2553_Anleitung_10_19 18.10.2019
LUMIO PLUS – Radio-controlled alarm clock
• Low batteries should be changed as soon as possible to prevent damage caused by leaking. Never use a combination of
old and new batteries together, nor batteries of different types.
• Wear chemical-resistant protective gloves and safety glasses when handling leaking batteries.
Important information on product safety!
• Do not expose the device to extreme temperatures, vibrations or shocks.
• Protect it from moisture.
5. Elements
A: Display (Fig. 1):
A 1: AM/PM (12-hour system)
A 3: Snooze symbol
A 5: Date
A 7: Alarm symbol
A 9: DST symbol
B: Back (Fig. 2):
B 1: Alarm ON/OFF switch
18
16:03 Uhr Seite 10
A 2: Time
A 4: Temperature
A 6: Alarm time
A 8: DCF reception symbol
B 2: 12/24/YEAR button
– 18 –
LUMIO PLUS – Radio-controlled alarm clock
B 3: MIN/DATE/°C/°F button B 4:
B 5: LOCK/SET switch B 6:
B 7: SNOOZE/LIGHT button B 8:
B 9: Battery compartment
6. Getting started
• Remove the protective film from the display.
• Open the battery compartment and insert three new AAA 1.5 V batteries.
• Close the battery compartment again.
• The indoor temperature (default °C) appears on the display.
6.1 Reception of the DCF frequency signal
• The clock will now scan the DCF frequency signal and the DCF symbol will be flashing on the display.
• When the time code is received after 3-7 minutes, the radio-controlled time will be shown. The DCF symbol remains on
the display.
• Activate the reception manually by holding the HOUR/MONTH button for 2 seconds. The clock will now scan the DCF fre-
quency signal and the DCF symbol flashes.
• To end the DCF reception attempt, press the HOUR/MONTH button again. The DCF reception symbol disappears.
HOUR/MONTH button
SENSOR ON/OFF switch
Light sensor
– 19 – 19