Publicité
Touch running mode
A. When you hold down the button, the system will play a 'Beep' prompt tone, and the system will start
to run.
After the speed is adjusted to the preset value, the system will play a 'Beep' prompt tone twice,
•
and the system will time and display. At this time, the time separator in the right window will
blink. Release the button and the system stops running mode.
NOTICE:
•
When the time parameter is set to '00:00', the instrument continues to run in countdown mode.
After the end of the timing, the instrument will stop automatically and give a 'Beep' prompt
•
tone and enter the configuration mode automatically.
•
The value adjustment of the left window is controlled by the left knob, and the value
adjustment of the right window is controlled by the right knob.
•
When using the timing function, the maximum time is 99 hours and 69 minutes, and the system
continues to run after the maximum time, but the timing stops.
•
Non-professionals should not handle faults with power on.
TROUBLESHOOTING
Problem
The display does not
light up after turning
There is no vortex in
the
liquid
after
operation
Large
instrument
vibration
The displayed speed
does not match the
actual speed.
The screen on the left
shows 8888.
The knob does not
work.
Excessive noise
Additional Notes:
A. Check the power cord connection to ensure that the external power supply meets the
requirements.
B. Restart the instrument after replacing the fuse. If the problem is still not resolved, please
contact the supplier.
C. Restart the instrument; if the problem still exists, please contact the supplier.
EN
Possible cause
The power is not connected.
The switch is damaged.
The speed setting is not
reasonable.
The upper tray is pressed too
loose.
Asymmetry of mixing position
Controller failure.
Motor drive circuit failure.
Broken button.
The
handwheel
tightened.
The parts are loose, etc.
Solution
Check the power supply
Change the switch
Reset the speed
Adjust the EVA Foam position
and press again
Place the mixture symmetrically
Contact the supplier
Contact the supplier
Contact the supplier
is
not
Tighten the left and right
handwheels
Contact the supplier
Publicité
