SEB AVANTI Mode D'emploi page 13

Table des Matières
Avanti SEB 2001.qxd
1
2
3
5
6
7
8
13/06/2001
15:21
Page 13
Bread roll toaster accessories
Description :
1 Bread roll holder (sold separately)
2 Loading command
Instructions for use :
• Unwind the power cord to its fullest extent and
connect.
• Insert the bread roll holder (fore-back clips).
• Set toasting time (button 3) to desired position
(1 to 3 max.).
• Lay the buns, bread rolls or croissants directly on
the bread holder.
• Press down the loading command located to the
left of the appliance.
Warning :
• Never place bread rolls or croissants directly on
the upper aperture of the appliance.
• Never use the appliance to warm up or defrost
frozen food trays.
Maintenance and cleaning - Fig. 6, 7 and 8
• To clean the toaster, unclip, open the crumb door
and wipe it clean. Also turn the appliance upside
down and shake out any pieces of bread that
may be stuck between the grills. (We recommend
that your clean the crumb door regularly). - Fig. 6
• Never insert any hard object into the bread slot
as this could damage the heating elements.
• To clean the exterior and the cord, wipe it down
with a damp cloth. Let it dry before using it again.
(depending on the model) - Fig. 5
3 Browning control 6 positions
• The bread rolls (croissants, etc.) will be ready
when the lever has risen.
• After use, allow the toaster to cool and
disconnect the appliance. Once the bread roll
holder has cooled, attach to rear of the
appliance.
• Never warm up bread rolls, croissants, etc., and
toast bread at the same time.
• Do not use scouring powders, abrasive pads,
wire or steel wool, oven cleaners or bleach.
• Never wrap the cord around the outside of the
appliance during or after use. A cord storage is
located under the appliance. - Fig. 7
• To move the toaster, a carrying handle is located
behind the appliance. - Fig. 8
«Subject to modifications !»
13
Table des Matières
loading

Table des Matières