Scott CHARGER Manuel page 9

3.2 Notes on the charging process
NOTE
The temperature of the Battery or Range Extender must be within the
permissible charging temperature range (0 °C to 40 °C / 32 °F to 104 °F).
Otherwise, the charging process will not be started.
— The drive system is deactivated in the following cases:
• While the Battery is charging.
• When the Range Extender is connected to the charging port of the
Battery in the bike frame and is charging.
— The state of charge of the Battery and the Range Extender can be read
separately on the Display.
— The state of charge of the Range Extender can also be read from the 6
LEDs located on the side of the Range Extender.
3.3 LED-states on the Charger
LED-state
Off
Red blinking
Green blinking
Green permanent
light
Red permanent
light
Tab. 2: LED-states on the Charger
EN – 8
Description
Charger is not connected to the power supply
Standby (no Battery connected)
charging
Charging process completed
Error (Overvoltage, undervoltage, short-circuit at
output, overcurrent, overtemperature, wrong polarity)