Publicité
However, it is strongly recommended to stop the
machine before opening the lid in order to avoid
splashing when working with liquids. Be especially
careful not to burn yourself when working with hot
liquid preparations.
•
If the blender is used for too long at a time and
wait until it has cooled down completely before
switching it on again (error A04).
• Overload safety device
If the blender is overloaded (spoon or utensil left in
the jug) or the preparation is too thick, the motor
will stop. This means that the preparation in the
blender is too thick or not suitable for preparation
in a blender. To start the blender again, follow the
usual operating procedure (error A03).
• No voltage safety device
If there is a power cut or the blender is disconnected,
it can only be restarted by following the normal
operating procedure.
R E M E N B E R
Never try to override the locking and safety
systems.
Never introduce any object into the container
where the food is being processed.
Never push the ingredients down with your
hand.
Do not overload the appliance
Your Kitchen Blender has a function for displaying
diagnosis codes.
• LIST OF CODES DISPLAYED
Code
displayed
A01
Safety systems:
The motor stops
A02
Bowl detection:
The motor does not start
A03
Motor overload:
The motor stops while in use.
A04
Normally-open AC drive failsafe
is overheating:
The motor stops while in use
A05
Safety systems:
The motor does not start
B01
B02
B03
C02
Speed inconsistency:
The motor does not start, or
stops while in use.
C04
Non-compliant braking:
The motor stops and does not
start again
C40
Displayed when the machine is
to C47
connected to the mains
Other
DIAGNOSIS
message
Consult the declaration of compliance on page 2.
Description
Cause
The lid or bowl becomes
unlocked while in use.
5L bowl used on a BL3
machine.
High overload on motor
High temperature measured in
the machine
Lid or bowl not locked when
the machine is turned on.
Preventive maintenance of
the belt
Preventive maintenance of the
carbon brushes
Preventive maintenance of the
support cartridge
The blades are blocked or the
motor rotation speed does not
match the selected speed.
Electronic component problem Contact after-sales
Code confirming the machine
is correctly configured.
STANDARDS
Action
standard display
Lock the lid and bowl then start the
Automatic
machine again.
Use a 3L bowl.
Automatic
Start the machine again, reducing the
Press the PULSE,
load or adding liquid to the preparation as
START or STOP
needed.
button
Let the machine cool down.
Automatic as soon
Check that the vents under the motor base
as the temperature
are not obstructed.
drops below 50°C
Reduce the load or add liquid to the
preparation as needed.
Lock the lid and/or bowl then start the
Automatic
machine again.
Changing the belt is recommended. Contact
Automatic
the after-sales service
Changing the brushes is recommended.
Automatic
Contact the after-sales service
Changing the support cartridge is
Automatic
recommended.
Contact the after-sales service
Unblock the blades or start at a higher
Press the PULSE
speed, then return to your working speed.
or START or STOP
Reduce the load or add liquid to the
button
preparation as needed.
Cannot be resolved
by the user
The code is displayed every time the
machine is connected to the mains
Contact after-sales
Return to
23
15/02/2023
Publicité
