Publicité
MOUNTING THE
JUG ON THE
MOTOR BASE
1) Before placing the jug on the motor base,
check that the blade is correctly positioned
with its seal and universal tool screw locked
into place. However, if the screw is not locked
into place, it will be secured when the jug is
locked onto the motor base.
2) With the motor base facing you, place the jug on
the motor base, with its handle slightly to the left.
3) Using the handle, turn the jug anti-clockwise until
it is locked in place. The handle will be facing you.
You will feel a slight resistance.
4) Pick up the lid, check that the seal is correctly
positioned and that the cap is screwed on tightly.
5) Place the lid on the jug, aligning shape 1 with lug
2 on the edge of the jug.
1
3
2
6) While holding the jug by the handle, using lever
3, turn the lid in the direction of the arrow (anti-
clockwise) until it is locked in place (lid handle
and jug handle aligned).
• The Kitchen Blender is equipped with safety
systems to ensure the jug and lid are both present.
If one of these two components is incorrectly
positioned, the blender will not work.
• Fill the jug with the
ingredients
to
be
blended, without going
above the Max level
indicated inside the jug.
This can be done whether the jug is on the Kitchen
Blender base or not. In general, add liquids before
solids.
• Place the lid on the jug.
• For very small quantities, the blade must be
totally immersed.
• Once the jug with its lid are correctly placed on
the motor base, turn on the Kitchen Blender.
Since the Kitchen Blender has a variable speed
function, always start at low speed and end with
the maximum speed for the preparation underway.
• If you want to add ingredients during blending,
remove the cap and add.
Hot liquid preparations
W A R N I N G
Use the handles provided when handling
the jug. Screw the cap on tightly.
• Use the same procedure as for cold preparations..
• Since the lid is equipped with a pressure-release
system when opened in order to protect the user
from spattering, it may be necessary to press
lightly on the back of the lid when opening in order
USES &
to get past safety notch 4.
EXAMPLES
It is recommend removing the lid when the jug is still
attached to the motor base.
Proceed as follows:
1)
Kitchen Blender by pressing the red button on
the front.
2) While holding the bowl by the handle, using lever
3, turn the lid in the direction of the arrow (anti-
clockwise) until it is locked in place. (Shape 1
against lug 2 of the jug).
If necessary, press lightly on the back of the lid so that
it can go past the pressure release safety notch 4 more
easily.
3) Raise the lid to remove. Place on a clean surface.
Make sure you do not place it on a hot surface.
4) To remove the jug from the motor base, unlock
using the handle to turn it clockwise, then raise.
4
REMOVING THE
JUG FROM THE
MOTOR BASE
19
15/02/2023
Publicité
