Placing The Pipe System First And Then Placing The Hearth; Opening The Door; Placing The Fireplace; Installing The Reducer - WANDERS Tali Mode D'emploi Et Instructions D'installation

• Connect the pipes vertically to the outlet of the hearth, press it in place and secure it with the clip.
• Determine the length of the pipes you need, and ensure that the adhesive strip or the universal tile is properly linked up with
the roof.
• Saw the outer pipe off to measure and link the roof outlet to the concentric pipes.
Placing the pipe system fi rst and then placing the hearth
You can also place the concentric pipe system before placing the appliance. In such case, ensure that you make the connection
with the appliance with an extendable pipe.

Opening the door

The door can be opened by unscrewing the screws as pointed out on the image below. The upper and lower panels are
attached with magnets and can easily be removed.
Watch out for fi nger marks!
Make sure to leave no fi nger marks on the cleaned glass pane when you close the hearth door. Finger marks
leave stains which will burn in the glass.
Placing the fi replace
• The appliance must be placed on a fl oor that is solid enough to hold it.
• It is forbidden use and/or to place fl ammable materials, such as curtains, in the vicinity of the appliance; it is safe to keep them
at a distance of at least 1.5m.

Installing the reducer

Depending on the length and shape of the concentric channel system Ø
100 - Ø 150 mm and the outlet construction, a restrictor with a diameter
of Ø 40 mm or Ø 60 mm according to the tables on page 26 must be
installed in the top of the combustion chamber. The standard culvert for
the fl ue gases is Ø 100 mm.
Ensure that the reducer is properly fi tted. Fitting the reducer
incorrectly may cause defects to the appliance.
GB
27