General; Batteries; Replacing The Batteries Of The Remote; Replacing The Batteries Of The Receiver - WANDERS Tali Mode D'emploi Et Instructions D'installation

General

It is common practice for the dealer where you purchased your gas fi replace to take also care of installing it and connecting it
to the gas mains. If this is not the case, please ensure that the installation is done by a certifi ed installer. Connecting gas devices
by unqualifi ed persons is prohibited, in which case we cannot give any guarantee that your gas hearth is functioning properly.

Batteries

The batteries of the remote handset and the receiver will last for about one year. We recommend that you use alkaline batteries.
You need to replace them when the LED of the remote set becomes dimmer and the word "BATT" appears in the display. The
receiver will warn you if it's batteries need to be exchanged. You'll hear, during ignition, a beep for 0.8 seconds followed by 0,2
seconds silence.

Replacing the batteries of the remote

Open the lid in the backside cover. Gently remove the 9V block battery and disconnect it
from the contact holder. Avoid pulling the cable. Connect the new battery, replace the set,
and close the lid.

Replacing the batteries of the receiver

Carefully pull the entire receiver from the bottom of the stove. Slide open the cover and
insert 4 new 1.5V batteries (type LR6 or AA). Please make sure to place the batteries in the
receiver in the proper way. Then return the receiver to the stove.

Setting the remote control handset (standard)

Once the batteries are placed, you need to set the electronic code (only when using it for the fi rst time). Press the reset button
on the receiver until you hear 2 acoustic signs, and then release the reset button. Then press the small fl ame button  within
20 seconds until you hear a long acoustic signal to confi rm that the code has been set.

Setting the time

• Press the big-fl ame button  and the small-fl ame button  simultaneously, and
the display will show short fl ashes to indicate that you are in the set mode.
• When in the set mode, press the big-fl ame button  to set the hours, and press the
small-fl ame button  to set the minutes.
Wait or press the OFF button  to return to manual control.
•
Switching from ºC/24-hour to ºF/12-hour indication
Press the OFF button  and the small fl ame button  simultaneously (2 sec) to
•
switch from ºF (and the 12-hour indication) to the ºC (and the 24-hour indication),
and vice versa.
GB
 
 
19