Sommaire des Matières pour Aurora NN138
- Page 1 Push Spreader with Metal Gear - 70 lb Capacity Épandeur à pousser avec engrenage métalique - Capacité de 70 lb NN138 User’s Manual - Manuel d’utilisation IMPORTANT: READ THIS MANUAL BEFORE USE IMPORTANT: LIRE CE MANUEL AVANT L’UTILISATION!
- Page 2 Component Parts / Pièces Frame Assembly 1pc Support Tube 1pc Support Leg 1pc Ensemble du cadre 1 pièce Tube de support 1 pièce Support 1 pièce Hopper Screen 1pc Rain Cover 1pc Left & Right Support Tube 2pcs Adjustment Lever 1pc Grille de trémie 1 pièce Couverture de pluie 1 Tube de support gauche et droit...
- Page 3 STEP 1 - Installing the Support Leg / ÉTAPE 1 : Installation du support 1. Attach the support leg (#29) to the installation tube assem- bly (#14) using step bolt M6x40 (#28), camber washer (#21) and nylon lock nut M6 (#13). 2.
- Page 4 Operation Instructions Before using the push spreader, review the instructions below and safety information. Failure to follow these instructions may result in property damage or injury to the operator or bystanders USING YOUR SPREADER 1. Inspect your spreader before each use. Make sure the wheels turn easily, and the gearbox moves when the spreader is pushed. The hopper should be clean and free from cracks.
- Page 5 Operation Instructions / Instructions d’utilisation Back Arrière Front Avant 3. Adjusting the handle to make sure the adjustable plate is fully open or closed, if not, please loosen the screw M6x40 and nylon lock nut M6, pull the control rod to make sure the adjust- able plate is fully open or closed.
- Page 6 Spreading Instructions / Instructions d’épandage CALCULATING AMOUNT OF MATERIAL NEEDED To calculate the amount of fertilizer you will need to cover your lawn, divide the coverage amount listed on the label by the weight of the fertilizer bag. For example a 10 lb bag of fertilizer with coverage of 10,000 square feet will distribute 1 lb of fertilizer every 1,000 square feet at full rate or ½ lb of fertil- izer every 1,000 square feet at half rate. For pre-calculated rates see Chart A (Example: 25 lb bag with 15,000 sq. Ft./pieds coverage = 1.7 lb/1,000 sq. Ft./pieds). Use Chart B to find the closest spreader setting (Example: 1.7 lb/1000 sq. Ft./pieds = Spreader Setting of 5).
- Page 7 Maintenance and Storage WARNING Improper maintenance and storage of the push spreader may void your warranty. MAINTENANCE • After each use clean material out of hopper. • Rinse/dry inside and outside of the spreader after each use. • Before operating make sure the tires have the RECOMMENDED TIRE PRESSURE 25 PSI. • Periodically check all fasteners for tightness. • Annually clean and lightly lubricate parts. • Use a glossy enamel spray paint to touch up scratched or worn painted metal surfaces.
- Page 8 PARTS LIST / LISTE DES PIÈCES...
- Page 9 PARTS LIST / LISTE DES PIÈCES Ref# Description Ref# Description Hopper Gear Box Trémie Boîte à engrenage Nylon Washer Left & Right Support Tube Rondelle en nylon Tube de support gauche et droit Inner Hex Screw M6x40 Step Bolt M6x40 Vis hexagonale intérieure M6 x 40 Boulon à...
- Page 10 NE JAMAIS utiliser par journées venteuses pour épandre des herbicides ou des graines de graminées. TOUJOURS faire preuve de prudence pour charger et décharger l’épandeur. TOUJOURS garder les pieds et les mains loin des pièces en mouvement. NE JAMAIS remorquer l’épandeur avec un véhicule motorisé. www.aurora-tools.com...