Remote Control - Novy Mini Pure'line 810 Mode D'emploi Et D'installation

3. OPERATION
You can control the hood by the switch on the hood or
by the remote control supplied.
Control on the hood:
① switch on / off
② decrease speed levels
③ and ④ Speed indicator lamps
⑤ increase speed levels
⑥ illumination
3.1 Extraction
Switch on – switch off
To switch the motor on push button ①.
The hood will always resume the level it was previously
switched off in.
Switch off with 10 minute delay:
Press button ① once. The first green Speed indicator
lamp blinks, the other Speed indicator lamps remain lit
up according to the level in use. After 10 minutes motor
and illumination switch off automatically.
Switch off without delay:
Push button ① twice.
Auto-Stop
To avoid that the hood will function during a too long
period, it will switch off automatically after 3 hours
(when no changes to the controls have been made).
Only the motor will turn off automatically. The lighting
will stay on.
Levels of intensity
To decrease speed levels push button ②. To increase
speed levels push button ⑤. Three green Speed in-
dicator lamps ③ indicate level 1 to 3, one red Speed
indicator lamp ④ indicates the level 'POWER'.
'POWER' is only used in case of excessive formation
of smoke, fumes or odours. Taking into account the
large volume of air which is extracted from the room at
this level, it's use should be limited.
'POWER' automatically reverts to level 3 after 6 min-
utes.
A self-rectifying thermal contact makes sure that
the motor is switched off when overheated. The mo-
tor will switch on again after is has cooled down. The
cause of the overheating needs to be determined. This
may be, for example, that the contents of the pan have
caught fire, the motor fan is blocked or an object is
(partly) closing off the exhaust opening.
3.2 Lightning
Press key ⑥ to switch the lighting on or off. The LED
lighting has a soft on/soft off mode, which means that
the lighting will evenly go on and off. When switching
on the lighting, this will always light up with full power
and it can also be used when the fan is off.
Dimming LED lighting
When the LED lighting has been switched on, it can be
dimmed by keeping key 6 pressed.
Change in colour temperature with LED-lighting
You can change the colour temperature of the LED-
lighting form 2.700 K (warm white) into 4.000 K (neutral
white). The description for changing this can be found
in section 4.4.

3.3 Remote control

1) illumination
2) increase speed levels
3) decrease speed levels
4) switch on / off
5) Novy-button - Not applicable
The remote control for hood is preinstalled and ready
for use.
Programming the remote control
If the set frequency disrupts other transmit-
ters, another code can be selected using the
remote control. There are 10 different codes.
Determine the code used
Simultaneously press
mote control flashes as many times as the selected
code (there are 10 code options in total).
Change the code:
• Simultaneously press
• The lamp on the remote control flashes as many
times as the selected code. Repeat this step until
you have reached the required code (there are 10
code options in total).
• Simultaneously press on the cookerhood
until the second green Speed indicator lamp is blink-
ing.
• Press the key on the remote control within 10
seconds to confirm the settings. The cooker hood
and the remote control are now in line with each
other.
and .The lamp on the re-
and .
+
EN 18