Würth APS 18 COMPACT Traduction Des Instructions De Service D'origine page 21

Ambient operating and
temperature for the tool and battery
pack
(Limited performance at temperatures
< 0°C)
Recommended ambient charging
temperature
Recommended battery type
Recommended charger
Device Elements
See page 3.
1. Speed control
2. On/off switch
3. Battery pack
4. Blade release lever
5. Blade cover
6. LED
7. Blade guard
8. Anti-splintering
9. Blade clamp sleeve
10. Blade
11. Orbital adjustment knob
12. LED switch
13. Base assembly
14. Dust port
*Speed control - A
See page 9.
When the speed is set at "A", the product runs at a reduced speed until
the blade engages the workpiece. The product speed will increase
automatically to provide the most effi cient cut.
NOTE: If the speed "A" activates itself, allow the product to run idle
for a few minutes. Then switch on the product again to disable the
"A" speed.
Intended Use
With appropriate blades fi tted, the product is designed to cut
wood, plastic, drywall, and metal up to the depth described in the
specifi cation table.
The product is designed for handheld use. The product is not to be
mounted onto a workbench unless specifi c instructions about how to
do this are given by the manufacturer of the product.
For damage caused by usage other than intended, the user is
responsible.
If the base plate is adjusted for a bevel cut, make sure the base plate
is mounted well when returning to the 0° position.
Symbols
Read all safety warnings and all instructions.
storage -15°C - 40 °C
5 - 40°C
LI 18V/2 Ah BASIC
LI 18V/4 Ah BASIC
LI 18V/5 Ah BASIC
ALG 18/4 BASIC
ALG 18/6 FAST
Warning
V Volts
Direct current
No-load speed
CE conformity
British Conformity Mark
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice.
Battery
A battery that is new or has not been used for a longer period does
not develop its full capacity until after approx. 2 – 3 charging/
discharging cycles.
Do not place down the battery on radiators or expose it to intense
sunlight for longer periods; temperatures above 50 °C cause damage.
Keep the contacts/terminals of the charger and replaceable battery
clean. For optimal service life, fully charge the battery after use.
Dust Extraction
Dusts from materials such as lead-containing coatings, some wood
types, minerals and metal can be harmful to one's health. Touching
or breathing-in the dusts can cause allergic reactions and/or lead to
respiratory infections of the user or bystanders.
Certain dusts, such as oak or beech dust, are considered carcinogenic,
especially in connection with wood-treatment additives (chromate,
wood preservative). Materials containing asbestos may only be
worked on by specialists.
□ Provide for good ventilation of the working place.
□ It is recommended to wear a P2 fi lter-class respirator.
Observe the relevant regulations in your country for the materials
being worked on.
Maintenance and Cleaning
□ Disconnect the plug from the power source and/or the battery
pack from the power tool before making any adjustments,
changing accessories or storing power tools. Such preventive
safety measure reduce the risk of starting the power tool
accidentally.
□ For safe and proper working, always keep the product and
ventilation slots clean. Therefore it is necessary to blow the
product by pneumatic air regularly.
□ After fulfi lling overhead-cutting, you have to blow out the tool and
move the blade release lever multiple times.
If the product should fail despite the care taken in manufacturing and
testing procedures, repair should be carried out by a Würth master-
21