Table des Matières
Publicité
CRN4500
Item No. 65690
1
16
OPERATINg ThE NAILER
MAINTENANCE AND INSPECTION
ƒ Disconnect air hose and remove nails from nailer when
doing maintenance and inspection, and clearing a jam.
A QUALIfIED PERSON ShOULD PERfORM
REPAIRS AND MAINTENANCE.
Inspecting the magazine:
ƒ Disconnect air hose.
ƒ Clean the magazine. Remove dust that may have
accumulated in the magazine.
ƒ Lubricate the nail rail with nailer lubricant.
Clearing a jam (in the following order):
ƒ Disconnect air hose.
ƒ Remove all nails.
ƒ Remove the jammed nail with a slotted head screwdriver.
ƒ Frequent jams: contact an authorized service center.
A QUALIfIED PERSON ShOULD PERfORM
REPAIRS AND MAINTENANCE.
Periodic maintenance to be performed:
ƒ Check that the piston bumper is operating normally.
ƒ Check o-rings for wear or damage.
ƒ Make sure all screws are secure.
ƒ When repairing a tool, make sure the internal parts are
clean and lubricated.
LUBRICATION
It is important that the tool be properly lubricated.
Without proper lubrication, the tool will not work properly
and parts will wear prematurely.
ƒ Use INTERCHANGE pneumatic tool lubricant. Do not
use detergent oil or additives. These lubricants will harm
the O-rings and other rubber parts. This will cause the
tool to malfunction.
ƒ Filter-regulator-lubricator units should always be
used. Keep the lubricator filled with INTERCHANGE
pneumatic tool lubricant.
1
ƒ If a lubricator is not available, supply 3 to 5 drops of
INTERCHANGE pneumatic tool lubricant into the air
plug on the tool twice a day.
Interchange Brands Coil Nailers: Operator's Manual
Publicité
Table des Matières
