Machine In Use; Machine Usage Advice - Numatic TTB-1620/100 Mode D'emploi

Table des Matières

Fig.25

Fig.26

Notes

........................................................................

Machine in use

To operate, turn the master control on/off key to the 'ON' position,

select water flow rate, lower the floor tool press the start / stop

trigger.

Vacuum pick-up, water-flow and chemical-dose will turn on

automatically and the machine will move forward.

The clean water / chemical mix is dispersed evenly via

'THRU- FEED' scrubbing brushes.

The waste water is then retrieved by the suction floor-tool.

Overlap each scrubbing path by 10cm to ensure

an even clean.

Do not operate the machine on inclines that exceed (2%), when

full.

NOTE: Care must be taken to reduce speed when

cornering or when manoeuvring around obstacles

On heavily soiled floors use a 'double scrub' technique (fig. 25).

First pre-scrub the floor with the floor-tool in the raised position,

allow the chemical time to work then scrub the area a second

time with the floor-tool lowered.

If streaking occurs wipe floor-tool blades clean (see fig.26)

Table des Matières