Publicité
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using 6mm Hexag-
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using 6mm Hexag-
onal Wrench, until the belt is centered itself; If belt shifts to left, tighten the left bolt and
onal Wrench, until the belt is centered itself; If belt shifts to left, tighten the left bolt and
loosen the right bolt by using 6mm Hexagonal Wrench, until the belt is centered. When
loosen the right bolt by using 6mm Hexagonal Wrench, until the belt is centered. When
adjusting the belt using the 6 mm Hexagonal Wrenches, it is important to adjust the belt in
adjusting the belt using the 6 mm Hexagonal Wrenches, it is important to adjust the belt in
half turn increments. Over adjusting the belt can cause damage to the mat.
half turn increments. Over adjusting the belt can cause damage to the mat.
This treadmill is designed in a way that in the event of an electrical fault, the machine will
This treadmill is designed in a way that in the event of an electrical fault, the machine will
turn off automatically to prevent any injuries to the user and to prevent damage to the
turn off automatically to prevent any injuries to the user and to prevent damage to the
machine (i.e. motor).
machine (i.e. motor).
When the treadmill behaves erratically, simply reset the treadmill by turning the power
When the treadmill behaves erratically, simply reset the treadmill by turning the power
switch off, waiting for 1 minute then turning the power button back on.
switch off, waiting for 1 minute then turning the power button back on.
If, after you have reset the treadmill, it is still not running correctly, please run the
If, after you have reset the treadmill, it is still not running correctly, please run the
self-checking analyse (please refer to Self-Checking) to distinguish what type of error
self-checking analyse (please refer to Self-Checking) to distinguish what type of error
problem the machine is encountering.
problem the machine is encountering.
5.1 Alarm signals
5.1 Alarm signals
E02 Over voltage protection of motor
E02 Over voltage protection of motor
1.Make the machine self-checking again
1.Make the machine self-checking again
2.Change controller
2.Change controller
E03 Over current protection
E03 Over current protection
1.Clean the dust between running board and belt, then put some oil
1.Clean the dust between running board and belt, then put some oil
2.If the running belt wear seriously, please change the running belt
2.If the running belt wear seriously, please change the running belt
E04 Motor open circuit
E04 Motor open circuit
1.Check the check the connect wire of motor ,if the connect wire loose, please connect it
1.Check the check the connect wire of motor ,if the connect wire loose, please connect it
again.
again.
2.The motor carbon brush wear, replace carbon brush or motor
2.The motor carbon brush wear, replace carbon brush or motor
E05 EEPROM damage or access problems change the controller board
E05 EEPROM damage or access problems change the controller board
E06 Communication error
E06 Communication error
1.Check the connect wire between computer and controller board, if it loose or broken,
1.Check the connect wire between computer and controller board, if it loose or broken,
please connect it again or change it
please connect it again or change it
2.change the incline motor
2.change the incline motor
5.TROUBLE SHOOTING
5.TROUBLE SHOOTING
16
EN
Publicité
