Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Rope lights - Lichtslangen - Lumineux - Mangueras luminosas - Lichtschlange
5.
Overview
Part
1
power cord
2
power connector
3
rope light
4
end cap
5
glue
6.
Initial Test
Always refer to the safety instructions above.
Before installing or using the rope light, test the rope light and keep it plugged in to warm up the plastic.
This makes it more pliable when installing.
7.
Assembling Rope Lights
This device shall be installed by qualified personnel only.
Switch off the mains power before you continue.
7.1
Connecting the Power Connector
1.
Slide the heatshrink over the rope light.
2.
Firmly push the sharp prongs of the power connector into the rope
light. Make sure the prongs are pushed in all the way and make
contact with the tube light leads.
3.
Push the power connector firmly into the connector sleeve.
4.
Use a heat gun to shrink the heatshrink over the connector.
V. 10 – 03/07/2015
Description
connects the power cord to the rope light
inner wires run the length of the rope light; can be cut at certain intervals
(cut marks are indicated on sheath
protects the exposed ends of the rope light
Apply glue only on the plastic parts – not on the conductive parts.
)
4
©Velleman nv
Publicité
Table des Matières
