Publicité
1
Introduction
EN
1.1
The product
SV
The product is a battery-powered soldering iron with a
pen-shaped handle and LED indicator with automatic
shut-off. Battery and charger and charger are not
NO
included
1.2
Dedicated use
PL
The product is used to bond or repair cables for example
to attach electrical components to a circuit boards, repair
broken metal objects, connect small metal parts and
DE
equivalent. Only for domestic use
1.3
Symbols
FI
Read the operating instructions carefully
and make sure that you understand the
FR
instructions before you use the product.
Save the instructions for future reference.
NL
This product complies with applicable EU
directives and regulations.
Recycle as electrical waste.
1.4 Product overview
Figure 1
1.
Battery (not included)
2.
Battery port
3.
Indicator lamp
4.
Soldering iron holder
5.
Soldering tip
6.
Handle
7.
Power button
Figure 2
8.
Brush nut
9.
Sleeve
10. Soldering tip
11.
Built in sleeve
12. Heating element
2
Safety
2.1
Safety definitions
Warning! If you do not obey these instructions,
there is a risk of death or injury.
4
Caution! If you do not obey these instructions,
there is a risk of damage to the product, other materials
or the adjacent area.
Note! Information that is necessary in a given situation.
2.2 Safety instructions for operation
Warning! If you do not obey these instructions,
there is a risk of death or injury.
Warning! Read all safety warnings and all instruc-
tions. Failure to follow the warnings and instructions may
result in electric shock, fire or serious injury.
Note! The product is battery-powered. Refer to the user
manuals for the battery and the charger for their safety
information.
● Read and obey the warning instructions before
operation.
● Do not use the product if you are tired, ill, or
intoxicated. This will decrease your vision, alertness,
coordination and judgement.
● Do not let children or persons who do not know the
product to use it.
● Do not use the product if it is damaged.
● Do not make changes or disassemble the product.
● Use the product only for its specified function.
● Wear approved safety glasses or a visor that complies
with the requirements in ANSI Z87.1 when you operate
or do maintenance on the product. This decreases the
risk of serious personal injury.
● Do not put the product directly on a table or bench
before it has become completely cool. Use the
supplied stand.
● Do not touch the soldering tip before it has become
completely cool because of the risk of burns.
● Only use the product in a well ventilated areas
because of the risk of inhaling harmful fumes and gas.
● Do not point the product at people or animals.
● Do not touch the soldering tip during operation.
Always think that the soldering tip is hot.
● Always supervise the product when it is switched to
ON.
● Keep the work area clean and well lit. Dark and
cluttered work areas increases the risk of accidents
Publicité
