Publicité
Les langues disponibles
Les langues disponibles
1. General information
The operating instructions must always be preserved during the lifetime of the product. It summarizes the
key safety measures.
It must be read by everyone working with the product so that they know to handle it properly.
The pendant control station Ex e must be used only for the purposes for which it was intended.
EX-TECH SOLUTION shall not be held liable for damages resulting from incorrect or improper use or non-
compliance with this manual.
Only authorized and trained persons are authorized to perform work on pendant control station Ex e
(installation, commissioning, maintenance, maintenance).
During installation and operation, it is imperious to follow the instructions (technical characteristics and
operating conditions) written on the marking plate of the increased safety enclosures Ex e.
2. Manufacturer
– Formerly Technor Atex
Ex-tech Solution
22, impasse de la Volute – Z.A. les Montagnes
B.P. 20708 – 16430 Champniers – France
Tel: + 33 5 45 93 01 10 – Fax : + 33 5 45 93 01 15
E-mail: sales.solution@ex-tech.no – www.ex-tech.no
3. Storage and transport
Check that the product was not damaged during the transport. If necessary, make a complaint to the
carrier
Never turn on damaged products
The product should be stored for a maximum of two years into a place dry (no condensation),
enclosed, covered, protected from contact with external chemicals and to temperatures of -40 ° C ... +
70 ° C and vibration-free
4. Use
The pendant control station Ex e described in this manual are certified II 2 GD and can operate into the
classified zones 1 and 2 for gases or 21 and 22 for dusts.
5. Function
The pendant control station certified for hazardous areas in protection mode Ex e are robust materials
designed to meet the highest requirements for use especially in the oil and gas, chemical, pharmaceutical
and food.
The pendant control station XAWP... are available in many sizes, in GRP. They are valuable for control,
monitoring, automation, distribution board, or any other applications. They are suitable for the design of
complex systems.
These enclosures are designed to receive:
Internally, electrical components certified for explosive atmospheres.
On the surface, components such as pushbuttons, switches, pilot lights that have be certified.
XAW170A12-02 01/12/2016
Operating instructions
Incresead safety pendant control station - XAWP series
ENG
7/12
Publicité
